APRS Track Direct

My position About ☰

reset

SQ7PKP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7PKP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1785839723	6 Count	162 Count	0 Count
1785837320	2 Count	80 Count	0 Count
1785836719	1 Count	57 Count	0 Count
1785836118	0 Count	29 Count	0 Count
1785835518	54 Count	1018 Count	36 Count
1785834917	53 Count	999 Count	36 Count
1785834316	52 Count	973 Count	36 Count
1785833715	51 Count	948 Count	36 Count
1785833114	50 Count	927 Count	36 Count
1785832514	49 Count	903 Count	36 Count
1785831913	48 Count	875 Count	36 Count
1785831312	47 Count	846 Count	36 Count
1785830711	46 Count	814 Count	36 Count
1785830110	45 Count	790 Count	36 Count
1785829509	44 Count	761 Count	36 Count
1785828307	40 Count	680 Count	34 Count
1785827706	35 Count	628 Count	30 Count
1785825904	17 Count	378 Count	15 Count
1785825303	14 Count	282 Count	13 Count
1785824702	4 Count	130 Count	4 Count
1785823500	91 Count	997 Count	65 Count
1785822899	86 Count	902 Count	61 Count
1785822298	78 Count	831 Count	54 Count
1785821697	70 Count	740 Count	47 Count
1785777923	384 Count	686 Count	9 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)