APRS Track Direct

My position About ☰

reset

YU7OPQ-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YU7OPQ-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*
1765022245	417 Count	32 Count
1765020441	414 Count	32 Count
1765018638	410 Count	32 Count
1765016834	407 Count	29 Count
1765013252	397 Count	29 Count
1765011448	393 Count	29 Count
1765009645	390 Count	29 Count
1765007841	386 Count	29 Count
1765006038	383 Count	29 Count
1765004234	379 Count	29 Count
1765002431	376 Count	29 Count
1764998849	366 Count	29 Count
1764997045	362 Count	29 Count
1764995242	359 Count	29 Count
1764993438	355 Count	29 Count
1764991634	352 Count	29 Count
1764989831	348 Count	29 Count
1764988028	345 Count	29 Count
1764984445	335 Count	29 Count
1764982642	331 Count	29 Count
1764980838	328 Count	29 Count
1764979034	324 Count	29 Count
1764977231	321 Count	29 Count
1764975427	317 Count	29 Count
1764973624	314 Count	29 Count

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 0.01, 0

Value5: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)