APRS Track Direct

My position About ☰

reset

SR8ULZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8ULZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791129774	661 Count	967 Count	401 Count
1791127974	652 Count	959 Count	393 Count
1791126173	650 Count	958 Count	392 Count
1791124373	648 Count	957 Count	391 Count
1791122572	646 Count	956 Count	390 Count
1791120773	644 Count	955 Count	389 Count
1791118971	642 Count	954 Count	388 Count
1791117170	640 Count	953 Count	387 Count
1791115369	638 Count	952 Count	386 Count
1791113569	636 Count	951 Count	385 Count
1791111768	634 Count	950 Count	384 Count
1791109974	628 Count	948 Count	383 Count
1791108174	626 Count	947 Count	382 Count
1791106373	624 Count	946 Count	381 Count
1791104572	622 Count	945 Count	380 Count
1791102772	620 Count	944 Count	379 Count
1791100971	618 Count	943 Count	378 Count
1791099170	616 Count	942 Count	377 Count
1791095569	611 Count	939 Count	374 Count
1791093768	608 Count	937 Count	372 Count
1791091968	605 Count	935 Count	370 Count
1791090167	602 Count	933 Count	368 Count
1791088373	595 Count	931 Count	366 Count
1791086573	592 Count	928 Count	364 Count
1791084772	589 Count	926 Count	362 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)