APRS Track Direct

My position About ☰

reset

SK3VJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SK3VJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791147042	141 Count	520 Count	127 Count
1791145239	128 Count	463 Count	115 Count
1791143436	113 Count	416 Count	101 Count
1791141633	102 Count	372 Count	91 Count
1791139830	90 Count	326 Count	80 Count
1791138027	81 Count	286 Count	72 Count
1791136224	69 Count	238 Count	61 Count
1791134421	55 Count	186 Count	48 Count
1791132651	40 Count	148 Count	38 Count
1791130848	24 Count	96 Count	23 Count
1791129045	11 Count	51 Count	11 Count
1791127242	257 Count	1009 Count	228 Count
1791125439	244 Count	965 Count	216 Count
1791123636	232 Count	916 Count	205 Count
1791121833	216 Count	860 Count	190 Count
1791120030	204 Count	803 Count	179 Count
1791118227	193 Count	755 Count	169 Count
1791116424	179 Count	698 Count	156 Count
1791114621	166 Count	645 Count	144 Count
1791112818	156 Count	600 Count	135 Count
1791111048	142 Count	563 Count	126 Count
1791109245	133 Count	518 Count	118 Count
1791105639	114 Count	428 Count	101 Count
1791103836	105 Count	384 Count	93 Count
1791102033	94 Count	338 Count	83 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)