APRS Track Direct

My position About ☰

reset

YO8PIC-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YO8PIC-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765022721	629 Count	636 Count	522 Count
1765022118	622 Count	629 Count	516 Count
1765021515	617 Count	624 Count	512 Count
1765020912	611 Count	618 Count	507 Count
1765020306	605 Count	612 Count	502 Count
1765019155	599 Count	607 Count	498 Count
1765018552	593 Count	601 Count	493 Count
1765017949	587 Count	595 Count	488 Count
1765017346	581 Count	589 Count	483 Count
1765016742	576 Count	584 Count	479 Count
1765016139	570 Count	578 Count	474 Count
1765015536	564 Count	572 Count	469 Count
1765014932	559 Count	568 Count	465 Count
1765014329	554 Count	563 Count	461 Count
1765013726	548 Count	557 Count	456 Count
1765013123	542 Count	552 Count	451 Count
1765012520	537 Count	547 Count	447 Count
1765011917	531 Count	541 Count	442 Count
1765011314	525 Count	535 Count	437 Count
1765010824	520 Count	530 Count	433 Count
1765010221	514 Count	524 Count	428 Count
1765009618	509 Count	519 Count	424 Count
1765009015	502 Count	512 Count	418 Count
1765008412	496 Count	506 Count	413 Count
1765007809	491 Count	501 Count	409 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)