APRS Track Direct

My position About ☰

reset

SZ1SV-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SZ1SV-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786205505	33 Count	40 Count	29 Count
1786204602	26 Count	32 Count	23 Count
1786203699	17 Count	22 Count	15 Count
1786202796	12 Count	16 Count	11 Count
1786201893	7 Count	9 Count	7 Count
1786200990	648 Count	1001 Count	506 Count
1786200087	644 Count	997 Count	503 Count
1786199184	637 Count	991 Count	497 Count
1786198280	630 Count	984 Count	491 Count
1786197377	625 Count	978 Count	487 Count
1786196474	621 Count	974 Count	484 Count
1786195571	617 Count	969 Count	481 Count
1786194668	609 Count	958 Count	474 Count
1786193765	603 Count	952 Count	469 Count
1786192862	598 Count	944 Count	465 Count
1786191959	595 Count	939 Count	463 Count
1786191056	588 Count	931 Count	457 Count
1786190153	586 Count	929 Count	456 Count
1786189250	585 Count	928 Count	456 Count
1786188346	582 Count	923 Count	454 Count
1786187443	577 Count	917 Count	450 Count
1786186540	573 Count	913 Count	447 Count
1786185639	568 Count	908 Count	443 Count
1786184734	565 Count	903 Count	441 Count
1786183831	560 Count	899 Count	437 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)