APRS Track Direct

My position About ☰

reset

PA1MT-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA1MT-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1780633722	184 Count	387 Count
1780631918	183 Count	384 Count
1780630115	182 Count	381 Count
1780628311	181 Count	378 Count
1780626508	180 Count	375 Count
1780624705	179 Count	372 Count
1780622901	178 Count	369 Count
1780621098	177 Count	366 Count
1780619332	172 Count	363 Count
1780617529	171 Count	360 Count
1780615726	170 Count	357 Count
1780613922	169 Count	354 Count
1780612119	168 Count	351 Count
1780610316	167 Count	348 Count
1780608512	166 Count	345 Count
1780604906	164 Count	339 Count
1780603102	163 Count	336 Count
1780601299	162 Count	333 Count
1780599496	161 Count	330 Count
1780597619	156 Count	330 Count
1780595816	155 Count	327 Count
1780594012	154 Count	324 Count
1780592209	153 Count	321 Count
1780590406	152 Count	318 Count
1780588602	151 Count	315 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)