APRS Track Direct

My position About ☰

reset

UN9GIE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN9GIE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1785861952	320 Count	440 Count
1785861349	319 Count	438 Count
1785860745	318 Count	437 Count
1785860142	317 Count	435 Count
1785859538	316 Count	433 Count
1785858935	315 Count	432 Count
1785858332	314 Count	430 Count
1785857728	313 Count	427 Count
1785857250	312 Count	426 Count
1785856647	311 Count	424 Count
1785856043	310 Count	422 Count
1785855440	309 Count	421 Count
1785854837	308 Count	419 Count
1785854233	307 Count	417 Count
1785853630	306 Count	416 Count
1785853026	305 Count	414 Count
1785852423	304 Count	412 Count
1785851819	303 Count	412 Count
1785851216	302 Count	409 Count
1785850612	301 Count	409 Count
1785850008	300 Count	408 Count
1785849405	299 Count	407 Count
1785848802	298 Count	406 Count
1785848198	297 Count	405 Count
1785847595	296 Count	403 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)