APRS Track Direct

My position About ☰

reset

SP7TBU-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7TBU-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1791109944	185 Count	966 Count	147 Count
1791108743	157 Count	890 Count	127 Count
1791106342	128 Count	784 Count	111 Count
1791105141	117 Count	731 Count	104 Count
1791103940	107 Count	686 Count	98 Count
1791102739	85 Count	601 Count	77 Count
1791101538	74 Count	514 Count	67 Count
1791100337	59 Count	393 Count	54 Count
1791099137	35 Count	212 Count	34 Count
1791097936	161 Count	1018 Count	146 Count
1791096734	133 Count	798 Count	120 Count
1791095533	103 Count	546 Count	94 Count
1791094331	72 Count	375 Count	65 Count
1791093130	50 Count	242 Count	45 Count
1791091945	25 Count	121 Count	21 Count
1791090745	221 Count	1054 Count	202 Count
1791089544	208 Count	976 Count	191 Count
1791088342	175 Count	820 Count	159 Count
1791087141	149 Count	670 Count	138 Count
1791085940	103 Count	478 Count	96 Count
1791084740	62 Count	304 Count	56 Count
1791083539	45 Count	209 Count	40 Count
1791082338	21 Count	93 Count	21 Count
1791081137	251 Count	1080 Count	222 Count
1791079936	229 Count	965 Count	202 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)