APRS Track Direct

My position About ☰

reset

SP2SGL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775251657	355 Count	530 Count	325 Count
1775249856	341 Count	508 Count	312 Count
1775248055	329 Count	489 Count	301 Count
1775246254	314 Count	468 Count	287 Count
1775244454	296 Count	443 Count	270 Count
1775242653	274 Count	414 Count	249 Count
1775240852	258 Count	391 Count	234 Count
1775239060	240 Count	367 Count	217 Count
1775237260	227 Count	348 Count	205 Count
1775235459	216 Count	331 Count	195 Count
1775233658	206 Count	316 Count	186 Count
1775231857	197 Count	301 Count	178 Count
1775230057	185 Count	285 Count	167 Count
1775228256	174 Count	269 Count	157 Count
1775226455	163 Count	254 Count	147 Count
1775224654	153 Count	237 Count	138 Count
1775222854	142 Count	220 Count	128 Count
1775221053	132 Count	207 Count	119 Count
1775219252	123 Count	193 Count	111 Count
1775217459	107 Count	171 Count	96 Count
1775215658	100 Count	158 Count	90 Count
1775213858	91 Count	144 Count	82 Count
1775212057	83 Count	131 Count	75 Count
1775210256	74 Count	118 Count	67 Count
1775208455	67 Count	106 Count	61 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)