APRS Track Direct

My position About ☰

reset

SN9GK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SN9GK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791125885	2 Count	145 Count
1791124084	1 Count	60 Count
1791122284	0 Count	0 Count
1791120492	12 Count	956 Count
1791118691	11 Count	895 Count
1791116891	10 Count	821 Count
1791115090	9 Count	760 Count
1791113289	8 Count	691 Count
1791111488	7 Count	603 Count
1791109687	6 Count	520 Count
1791107887	5 Count	446 Count
1791106086	4 Count	368 Count
1791104285	3 Count	311 Count
1791102484	2 Count	263 Count
1791100683	1 Count	201 Count
1791098891	0 Count	119 Count
1791097091	8 Count	1066 Count
1791095290	7 Count	909 Count
1791093489	6 Count	777 Count
1791091688	5 Count	679 Count
1791089887	4 Count	598 Count
1791088087	3 Count	463 Count
1791086286	2 Count	316 Count
1791084485	1 Count	168 Count
1791082684	0 Count	70 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)