APRS Track Direct

My position About ☰

reset

SP9EPW-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9EPW-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780646475	125 Count	936 Count	97 Count
1780644674	119 Count	925 Count	92 Count
1780642873	114 Count	908 Count	88 Count
1780639279	98 Count	877 Count	78 Count
1780637478	93 Count	832 Count	74 Count
1780633877	81 Count	780 Count	64 Count
1780632076	76 Count	733 Count	60 Count
1780630275	69 Count	667 Count	54 Count
1780628475	64 Count	577 Count	50 Count
1780626674	58 Count	515 Count	45 Count
1780624873	53 Count	454 Count	41 Count
1780623072	48 Count	386 Count	37 Count
1780621272	42 Count	314 Count	32 Count
1780617678	28 Count	221 Count	24 Count
1780615878	22 Count	156 Count	19 Count
1780614077	17 Count	108 Count	15 Count
1780612276	11 Count	67 Count	10 Count
1780610478	5 Count	25 Count	5 Count
1780608677	393 Count	1001 Count	294 Count
1780606874	387 Count	982 Count	289 Count
1780605073	382 Count	964 Count	285 Count
1780603273	376 Count	951 Count	280 Count
1780601474	371 Count	939 Count	276 Count
1780599671	367 Count	924 Count	273 Count
1780596078	352 Count	902 Count	264 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)