APRS Track Direct

My position About ☰

reset

SR2CSR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2CSR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791191159	137 Count	267 Count	124 Count
1791189358	122 Count	232 Count	110 Count
1791187567	102 Count	202 Count	96 Count
1791185766	88 Count	175 Count	83 Count
1791183965	67 Count	143 Count	64 Count
1791182164	45 Count	106 Count	43 Count
1791178563	603 Count	1062 Count	546 Count
1791176762	583 Count	994 Count	528 Count
1791174961	558 Count	947 Count	504 Count
1791171359	510 Count	867 Count	459 Count
1791169558	481 Count	821 Count	432 Count
1791167757	460 Count	783 Count	412 Count
1791165964	431 Count	735 Count	389 Count
1791162364	384 Count	645 Count	345 Count
1791160563	364 Count	609 Count	326 Count
1791158762	350 Count	586 Count	314 Count
1791156961	336 Count	560 Count	301 Count
1791155160	317 Count	532 Count	284 Count
1791153360	297 Count	505 Count	265 Count
1791151559	280 Count	480 Count	250 Count
1791149758	264 Count	456 Count	235 Count
1791147957	243 Count	427 Count	216 Count
1791146156	217 Count	394 Count	191 Count
1791144364	186 Count	343 Count	166 Count
1791142563	170 Count	312 Count	151 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 1, 0

V_Ext: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)