APRS Track Direct

My position About ☰

reset

YC2SNK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YC2SNK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1785871116	54 Count	946 Count
1785869312	53 Count	926 Count
1785865745	51 Count	889 Count
1785863941	50 Count	874 Count
1785862137	49 Count	856 Count
1785860334	48 Count	838 Count
1785858530	47 Count	821 Count
1785856726	46 Count	802 Count
1785854922	45 Count	783 Count
1785853118	44 Count	768 Count
1785851314	43 Count	757 Count
1785849510	42 Count	743 Count
1785847706	41 Count	727 Count
1785845945	40 Count	712 Count
1785844141	39 Count	695 Count
1785842337	38 Count	677 Count
1785840533	37 Count	661 Count
1785838729	36 Count	641 Count
1785836925	35 Count	627 Count
1785835121	34 Count	618 Count
1785833317	33 Count	602 Count
1785831514	32 Count	586 Count
1785829710	31 Count	570 Count
1785827906	30 Count	552 Count
1785826102	29 Count	534 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)