APRS Track Direct

My position About ☰

reset

F4GCF-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GCF-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1785871416	814 Count	390 Count
1785870816	803 Count	384 Count
1785870216	792 Count	380 Count
1785869028	766 Count	368 Count
1785868415	751 Count	363 Count
1785867815	738 Count	357 Count
1785867215	731 Count	353 Count
1785866615	717 Count	346 Count
1785866015	714 Count	343 Count
1785865415	709 Count	339 Count
1785864815	691 Count	333 Count
1785863615	633 Count	301 Count
1785863014	613 Count	289 Count
1785862414	608 Count	285 Count
1785861814	599 Count	281 Count
1785861214	584 Count	273 Count
1785860614	568 Count	267 Count
1785860014	562 Count	263 Count
1785859414	551 Count	257 Count
1785858814	542 Count	251 Count
1785858214	534 Count	246 Count
1785857613	521 Count	240 Count
1785857013	512 Count	234 Count
1785856413	503 Count	229 Count
1785855813	492 Count	224 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)