APRS Track Direct

My position About ☰

reset

IT9IRS-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785829963	129 Count	298 Count	66 Count
1785829658	127 Count	295 Count	65 Count
1785829365	121 Count	291 Count	64 Count
1785829060	119 Count	282 Count	63 Count
1785828756	117 Count	278 Count	62 Count
1785828452	115 Count	276 Count	61 Count
1785828147	112 Count	270 Count	59 Count
1785827843	110 Count	267 Count	58 Count
1785827538	109 Count	263 Count	58 Count
1785827234	107 Count	260 Count	57 Count
1785826929	105 Count	258 Count	56 Count
1785826625	104 Count	256 Count	56 Count
1785826320	102 Count	251 Count	55 Count
1785826016	99 Count	245 Count	53 Count
1785825712	98 Count	241 Count	53 Count
1785825407	95 Count	234 Count	51 Count
1785825103	92 Count	229 Count	49 Count
1785824798	91 Count	222 Count	49 Count
1785824494	88 Count	215 Count	47 Count
1785824189	86 Count	210 Count	46 Count
1785823885	85 Count	207 Count	46 Count
1785823581	83 Count	203 Count	45 Count
1785823276	80 Count	198 Count	43 Count
1785822972	78 Count	191 Count	42 Count
1785822667	76 Count	185 Count	41 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)