APRS Track Direct

My position About ☰

reset

SP8PB-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8PB-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769674784	303 Count	615 Count	225 Count
1769673883	299 Count	606 Count	222 Count
1769672983	295 Count	598 Count	219 Count
1769672082	287 Count	586 Count	212 Count
1769671181	283 Count	579 Count	209 Count
1769670281	279 Count	571 Count	206 Count
1769669380	275 Count	562 Count	203 Count
1769668480	271 Count	555 Count	200 Count
1769667579	267 Count	547 Count	197 Count
1769666679	263 Count	538 Count	194 Count
1769665778	260 Count	531 Count	192 Count
1769664877	256 Count	523 Count	189 Count
1769663977	252 Count	514 Count	186 Count
1769663076	248 Count	507 Count	183 Count
1769662175	245 Count	501 Count	181 Count
1769661275	241 Count	493 Count	178 Count
1769660374	237 Count	484 Count	175 Count
1769659474	233 Count	476 Count	172 Count
1769658573	229 Count	467 Count	169 Count
1769657672	225 Count	458 Count	166 Count
1769656772	221 Count	450 Count	163 Count
1769655871	217 Count	442 Count	160 Count
1769654970	213 Count	433 Count	157 Count
1769654070	209 Count	424 Count	154 Count
1769653169	205 Count	417 Count	151 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)