APRS Track Direct

My position About ☰

reset

SP2AJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2AJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791121602	276 Count	386 Count	217 Count
1791120702	272 Count	381 Count	214 Count
1791119801	267 Count	375 Count	210 Count
1791118900	261 Count	367 Count	205 Count
1791117999	256 Count	361 Count	201 Count
1791117098	250 Count	354 Count	196 Count
1791116198	245 Count	347 Count	192 Count
1791115297	240 Count	340 Count	188 Count
1791114396	236 Count	334 Count	185 Count
1791113495	231 Count	327 Count	181 Count
1791112594	225 Count	319 Count	176 Count
1791111694	216 Count	308 Count	168 Count
1791110793	207 Count	297 Count	160 Count
1791109892	199 Count	288 Count	153 Count
1791108991	196 Count	283 Count	151 Count
1791107190	187 Count	271 Count	144 Count
1791106305	184 Count	269 Count	142 Count
1791105404	180 Count	264 Count	139 Count
1791104511	176 Count	258 Count	136 Count
1791103602	171 Count	251 Count	132 Count
1791102701	166 Count	245 Count	128 Count
1791101801	163 Count	240 Count	126 Count
1791100900	160 Count	235 Count	124 Count
1791099999	156 Count	230 Count	121 Count
1791099098	154 Count	228 Count	120 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)