APRS Track Direct

My position About ☰

reset

SP6RSP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RSP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769926593	429 Count	943 Count	146 Count
1769926292	427 Count	942 Count	146 Count
1769925992	426 Count	938 Count	146 Count
1769925691	424 Count	936 Count	145 Count
1769925390	422 Count	930 Count	145 Count
1769925090	421 Count	929 Count	145 Count
1769924789	419 Count	924 Count	144 Count
1769924488	417 Count	923 Count	144 Count
1769924188	416 Count	921 Count	144 Count
1769923887	414 Count	918 Count	143 Count
1769923586	411 Count	915 Count	142 Count
1769923286	410 Count	915 Count	142 Count
1769922985	408 Count	911 Count	141 Count
1769922684	405 Count	909 Count	140 Count
1769922384	404 Count	909 Count	140 Count
1769922083	402 Count	903 Count	139 Count
1769921782	399 Count	902 Count	139 Count
1769921481	397 Count	900 Count	138 Count
1769921271	395 Count	898 Count	137 Count
1769920971	392 Count	894 Count	136 Count
1769920670	391 Count	894 Count	136 Count
1769920370	388 Count	889 Count	134 Count
1769920069	386 Count	887 Count	134 Count
1769919768	384 Count	885 Count	133 Count
1769919467	382 Count	882 Count	132 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)