APRS Track Direct

My position About ☰

reset

MW0KEC-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MW0KEC-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770096370	146 Count	166 Count	60 Count
1770094567	142 Count	161 Count	57 Count
1770092764	137 Count	150 Count	53 Count
1770090961	132 Count	138 Count	49 Count
1770089158	127 Count	129 Count	45 Count
1770087399	124 Count	121 Count	43 Count
1770085596	121 Count	114 Count	41 Count
1770083792	116 Count	107 Count	37 Count
1770081989	110 Count	97 Count	32 Count
1770080185	105 Count	87 Count	28 Count
1770078382	99 Count	75 Count	23 Count
1770076579	95 Count	65 Count	20 Count
1770074776	91 Count	56 Count	17 Count
1770072969	85 Count	46 Count	12 Count
1770071166	80 Count	37 Count	8 Count
1770069363	67 Count	19 Count	3 Count
1770067559	20 Count	0 Count	0 Count
1770067236	18 Count	0 Count	0 Count
1770067144	17 Count	0 Count	0 Count
1770066394	16 Count	0 Count	0 Count
1770065155	15 Count	0 Count	0 Count
1770064446	14 Count	0 Count	0 Count
1770064415	13 Count	0 Count	0 Count
1770064198	2 Count	0 Count	0 Count
1770064111	1 Count	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)