APRS Track Direct

My position About ☰

reset

SQ9MJ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9MJ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791088724	50 Count	858 Count	27 Count
1791087823	49 Count	828 Count	27 Count
1791086922	47 Count	801 Count	27 Count
1791086021	45 Count	767 Count	26 Count
1791085139	41 Count	725 Count	23 Count
1791084238	39 Count	685 Count	22 Count
1791083337	35 Count	638 Count	20 Count
1791082436	34 Count	586 Count	20 Count
1791081535	31 Count	539 Count	18 Count
1791080634	29 Count	496 Count	17 Count
1791079733	25 Count	448 Count	15 Count
1791078832	23 Count	394 Count	14 Count
1791077931	18 Count	335 Count	10 Count
1791077030	16 Count	283 Count	9 Count
1791076129	12 Count	229 Count	7 Count
1791075228	10 Count	184 Count	6 Count
1791074327	7 Count	133 Count	4 Count
1791073426	5 Count	92 Count	3 Count
1791072525	1 Count	39 Count	1 Count
1791071624	51 Count	1027 Count	10 Count
1791070723	46 Count	972 Count	6 Count
1791069822	44 Count	923 Count	5 Count
1791068921	40 Count	865 Count	3 Count
1791068020	39 Count	830 Count	3 Count
1791067119	36 Count	790 Count	1 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)