APRS Track Direct

My position About ☰

reset

LB3AG-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LB3AG-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785836004	97 Count	112 Count	68 Count
1785835401	96 Count	110 Count	68 Count
1785834798	93 Count	107 Count	66 Count
1785834195	90 Count	104 Count	64 Count
1785833592	89 Count	102 Count	64 Count
1785832989	86 Count	98 Count	62 Count
1785832386	83 Count	95 Count	60 Count
1785831783	82 Count	95 Count	60 Count
1785831180	80 Count	93 Count	59 Count
1785830094	76 Count	88 Count	57 Count
1785828284	69 Count	81 Count	53 Count
1785827078	43 Count	51 Count	29 Count
1785825269	35 Count	41 Count	24 Count
1785824660	34 Count	38 Count	24 Count
1785824057	30 Count	34 Count	21 Count
1785822852	25 Count	30 Count	18 Count
1785822254	21 Count	25 Count	15 Count
1785821048	16 Count	19 Count	12 Count
1785820439	12 Count	14 Count	9 Count
1785819238	7 Count	9 Count	6 Count
1785818630	3 Count	4 Count	3 Count
1785818026	710 Count	1001 Count	493 Count
1785817423	709 Count	998 Count	493 Count
1785816820	705 Count	993 Count	490 Count
1785816217	701 Count	988 Count	487 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)