APRS Track Direct

My position About ☰

reset

F4GMT-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GMT-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791191580	286 Count	615 Count
1791190680	285 Count	613 Count
1791189779	284 Count	610 Count
1791188878	283 Count	608 Count
1791187977	282 Count	605 Count
1791187076	281 Count	603 Count
1791186176	280 Count	600 Count
1791185275	279 Count	598 Count
1791184374	278 Count	595 Count
1791183473	277 Count	593 Count
1791182573	276 Count	590 Count
1791156485	239 Count	518 Count
1791155585	238 Count	515 Count
1791154684	237 Count	513 Count
1791153783	236 Count	510 Count
1791152882	235 Count	508 Count
1791151981	234 Count	505 Count
1791151081	233 Count	503 Count
1791150180	232 Count	500 Count
1791149279	231 Count	498 Count
1791148378	230 Count	495 Count
1791147477	229 Count	493 Count
1791146577	228 Count	490 Count
1791145676	227 Count	488 Count
1791144775	226 Count	485 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)