APRS Track Direct

My position About ☰

reset

SP9KKK-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1785828979	0 Count	0 Count
1785827790	28 Count	946 Count
1785826589	22 Count	838 Count
1785825388	13 Count	662 Count
1785824187	7 Count	431 Count
1785822986	3 Count	212 Count
1785821785	27 Count	1012 Count
1785820584	23 Count	865 Count
1785819383	20 Count	731 Count
1785818182	14 Count	560 Count
1785816981	10 Count	420 Count
1785815780	7 Count	316 Count
1785814579	4 Count	159 Count
1785813388	20 Count	1022 Count
1785812187	17 Count	889 Count
1785810986	15 Count	723 Count
1785809785	11 Count	579 Count
1785808584	8 Count	438 Count
1785807384	6 Count	287 Count
1785806183	2 Count	124 Count
1785804982	22 Count	1057 Count
1785803781	18 Count	870 Count
1785802580	14 Count	664 Count
1785801379	10 Count	484 Count
1785800178	7 Count	295 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)