APRS Track Direct

My position About ☰

reset

SQ3NVZ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3NVZ-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791093283	130 Count	772 Count	92 Count
1791091482	107 Count	712 Count	70 Count
1791089681	103 Count	683 Count	67 Count
1791087880	100 Count	653 Count	65 Count
1791086078	96 Count	640 Count	62 Count
1791084277	93 Count	632 Count	60 Count
1791082476	89 Count	620 Count	57 Count
1791080675	86 Count	610 Count	55 Count
1791078874	81 Count	598 Count	51 Count
1791077073	78 Count	587 Count	49 Count
1791075271	74 Count	573 Count	46 Count
1791073509	71 Count	561 Count	44 Count
1791071708	67 Count	549 Count	41 Count
1791069906	64 Count	539 Count	39 Count
1791068105	60 Count	530 Count	36 Count
1791066304	58 Count	525 Count	35 Count
1791064503	55 Count	517 Count	33 Count
1791062702	52 Count	508 Count	31 Count
1791060901	48 Count	500 Count	28 Count
1791059099	45 Count	490 Count	26 Count
1791057298	40 Count	480 Count	22 Count
1791055497	37 Count	465 Count	20 Count
1791053697	33 Count	398 Count	17 Count
1791051895	30 Count	338 Count	15 Count
1791050093	26 Count	275 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)