APRS Track Direct

My position About ☰

reset

SR2DTW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2DTW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791128863	11 Count	265 Count	1 Count
1791127182	10 Count	233 Count	1 Count
1791125502	9 Count	194 Count	1 Count
1791123821	7 Count	164 Count	0 Count
1791122389	2 Count	121 Count	0 Count
1791120708	1 Count	84 Count	0 Count
1791119027	0 Count	34 Count	0 Count
1791117347	56 Count	1027 Count	16 Count
1791115666	55 Count	984 Count	16 Count
1791113985	50 Count	956 Count	12 Count
1791112304	46 Count	925 Count	9 Count
1791110624	43 Count	892 Count	7 Count
1791108943	42 Count	857 Count	7 Count
1791105581	40 Count	780 Count	7 Count
1791103900	39 Count	724 Count	7 Count
1791102220	38 Count	693 Count	7 Count
1791100788	33 Count	671 Count	7 Count
1791099107	32 Count	644 Count	7 Count
1791095746	28 Count	589 Count	5 Count
1791094065	26 Count	558 Count	4 Count
1791092384	25 Count	529 Count	4 Count
1791090703	23 Count	494 Count	3 Count
1791089023	22 Count	457 Count	3 Count
1791087342	20 Count	425 Count	2 Count
1791085661	19 Count	396 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)