APRS Track Direct

My position About ☰

reset

SR2CA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2CA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791104942	843 Count	623 Count	497 Count
1791103261	837 Count	592 Count	492 Count
1791101579	832 Count	564 Count	490 Count
1791099898	829 Count	544 Count	488 Count
1791098218	826 Count	525 Count	486 Count
1791096537	822 Count	504 Count	484 Count
1791055983	814 Count	482 Count	482 Count
1791054301	802 Count	472 Count	472 Count
1791050063	798 Count	472 Count	472 Count
1791048631	790 Count	468 Count	468 Count
1791046950	786 Count	465 Count	465 Count
1791045269	783 Count	463 Count	463 Count
1791043589	778 Count	459 Count	459 Count
1791041908	775 Count	457 Count	457 Count
1791040227	772 Count	455 Count	455 Count
1791038546	769 Count	453 Count	453 Count
1791036865	766 Count	451 Count	451 Count
1791035185	763 Count	449 Count	449 Count
1791033504	756 Count	443 Count	443 Count
1791031823	751 Count	439 Count	439 Count
1791030142	750 Count	439 Count	439 Count
1791027030	741 Count	436 Count	436 Count
1791025349	738 Count	434 Count	434 Count
1791023668	735 Count	432 Count	432 Count
1791021987	730 Count	428 Count	428 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)