APRS Track Direct

My position About ☰

reset

SR2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769643951	152 Count	509 Count	151 Count
1769642150	89 Count	267 Count	89 Count
1769640350	331 Count	1207 Count	327 Count
1769638548	251 Count	956 Count	248 Count
1769636747	185 Count	704 Count	183 Count
1769634947	127 Count	473 Count	126 Count
1769633146	68 Count	242 Count	68 Count
1769631346	283 Count	1054 Count	280 Count
1769629545	220 Count	810 Count	218 Count
1769627745	151 Count	557 Count	150 Count
1769625944	78 Count	274 Count	78 Count
1769624143	351 Count	1101 Count	345 Count
1769622342	283 Count	845 Count	278 Count
1769620542	224 Count	604 Count	220 Count
1769618741	156 Count	360 Count	153 Count
1769616941	92 Count	230 Count	90 Count
1769615140	60 Count	140 Count	59 Count
1769613339	36 Count	84 Count	36 Count
1769611538	504 Count	1056 Count	475 Count
1769609738	477 Count	994 Count	449 Count
1769607937	415 Count	874 Count	388 Count
1769606137	375 Count	785 Count	349 Count
1769604336	339 Count	705 Count	314 Count
1769602535	294 Count	635 Count	280 Count
1769600735	271 Count	582 Count	258 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)