APRS Track Direct

My position About ☰

reset

SP3PSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3PSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785836234	51 Count	452 Count	46 Count
1785834441	28 Count	316 Count	28 Count
1785832641	73 Count	1016 Count	69 Count
1785830840	55 Count	724 Count	52 Count
1785829039	36 Count	527 Count	34 Count
1785827238	12 Count	282 Count	11 Count
1785825437	7 Count	135 Count	7 Count
1785823637	91 Count	1032 Count	81 Count
1785821836	72 Count	710 Count	63 Count
1785820035	52 Count	445 Count	44 Count
1785818234	45 Count	295 Count	38 Count
1785816433	33 Count	196 Count	27 Count
1785814633	24 Count	132 Count	19 Count
1785812840	8 Count	64 Count	8 Count
1785811040	151 Count	1041 Count	132 Count
1785809239	140 Count	977 Count	122 Count
1785807438	131 Count	924 Count	114 Count
1785805637	120 Count	865 Count	104 Count
1785803836	110 Count	812 Count	95 Count
1785802036	99 Count	756 Count	85 Count
1785800235	91 Count	701 Count	78 Count
1785798434	85 Count	662 Count	73 Count
1785796633	76 Count	596 Count	65 Count
1785794832	68 Count	555 Count	58 Count
1785793032	59 Count	499 Count	50 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)