APRS Track Direct

My position About ☰

reset

SP8PB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8PB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1791091899	118 Count	768 Count
1791090098	116 Count	742 Count
1791089197	115 Count	729 Count
1791088296	114 Count	716 Count
1791087395	113 Count	706 Count
1791086494	112 Count	694 Count
1791085594	111 Count	686 Count
1791084693	110 Count	676 Count
1791083792	109 Count	663 Count
1791082891	108 Count	651 Count
1791081990	107 Count	639 Count
1791081090	106 Count	626 Count
1791080189	105 Count	620 Count
1791079288	104 Count	607 Count
1791078387	103 Count	586 Count
1791077487	102 Count	575 Count
1791076586	101 Count	562 Count
1791075685	100 Count	549 Count
1791074784	99 Count	536 Count
1791073883	98 Count	524 Count
1791072983	97 Count	517 Count
1791072082	96 Count	509 Count
1791071181	95 Count	496 Count
1791070280	94 Count	485 Count
1791068479	92 Count	459 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)