APRS Track Direct

My position About ☰

reset

SP3NGH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3NGH-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775210296	326 Count	531 Count	89 Count
1775208495	322 Count	531 Count	89 Count
1775206722	318 Count	531 Count	89 Count
1775204921	314 Count	531 Count	89 Count
1775203120	310 Count	531 Count	89 Count
1775201319	306 Count	531 Count	89 Count
1775199517	302 Count	527 Count	89 Count
1775197716	295 Count	518 Count	89 Count
1775195915	290 Count	508 Count	88 Count
1775194113	285 Count	498 Count	87 Count
1775192312	279 Count	484 Count	86 Count
1775190511	274 Count	476 Count	85 Count
1775188710	269 Count	468 Count	84 Count
1775186909	264 Count	459 Count	83 Count
1775185108	259 Count	449 Count	82 Count
1775183307	254 Count	427 Count	81 Count
1775181506	249 Count	419 Count	80 Count
1775179705	244 Count	411 Count	79 Count
1775177904	239 Count	402 Count	78 Count
1775176103	234 Count	394 Count	77 Count
1775174302	230 Count	390 Count	77 Count
1775172501	226 Count	390 Count	77 Count
1775170700	222 Count	390 Count	77 Count
1775168899	218 Count	390 Count	77 Count
1775167097	214 Count	390 Count	77 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)