APRS Track Direct

My position About ☰

reset

F6DAY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6DAY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791127296	957 Count	678 Count	641 Count
1791126332	954 Count	676 Count	639 Count
1791125368	953 Count	676 Count	639 Count
1791124404	949 Count	673 Count	636 Count
1791122476	942 Count	668 Count	631 Count
1791121512	938 Count	665 Count	628 Count
1791120548	935 Count	663 Count	626 Count
1791119594	932 Count	661 Count	624 Count
1791118620	930 Count	660 Count	623 Count
1791117656	926 Count	657 Count	620 Count
1791116692	923 Count	655 Count	618 Count
1791115728	920 Count	653 Count	616 Count
1791114764	917 Count	651 Count	614 Count
1791114373	914 Count	649 Count	612 Count
1791113409	911 Count	647 Count	610 Count
1791112445	907 Count	644 Count	607 Count
1791111481	904 Count	642 Count	605 Count
1791110517	901 Count	640 Count	603 Count
1791109553	897 Count	637 Count	600 Count
1791108589	895 Count	636 Count	599 Count
1791107625	891 Count	633 Count	596 Count
1791106661	889 Count	632 Count	595 Count
1791105697	884 Count	628 Count	591 Count
1791104733	880 Count	625 Count	588 Count
1791103769	877 Count	623 Count	586 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)