APRS Track Direct

My position About ☰

reset

LW2DHT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785867587	468 Count	526 Count	363 Count
1785865784	456 Count	514 Count	352 Count
1785863981	444 Count	501 Count	341 Count
1785862178	439 Count	496 Count	337 Count
1785860375	434 Count	490 Count	333 Count
1785856804	421 Count	482 Count	326 Count
1785853198	411 Count	472 Count	318 Count
1785851394	404 Count	465 Count	312 Count
1785849591	399 Count	460 Count	308 Count
1785847788	395 Count	456 Count	305 Count
1785845984	390 Count	451 Count	301 Count
1785844181	386 Count	447 Count	298 Count
1785842378	382 Count	443 Count	295 Count
1785840576	377 Count	438 Count	291 Count
1785838772	365 Count	422 Count	280 Count
1785836969	339 Count	393 Count	255 Count
1785835216	330 Count	388 Count	251 Count
1785833413	326 Count	384 Count	248 Count
1785831609	320 Count	378 Count	243 Count
1785829807	315 Count	373 Count	239 Count
1785828003	310 Count	368 Count	235 Count
1785791217	261 Count	320 Count	198 Count
1785789414	256 Count	315 Count	194 Count
1785787611	251 Count	310 Count	190 Count
1785785808	244 Count	302 Count	184 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)