APRS Track Direct

My position About ☰

reset

SP6PTT Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6PTT. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791101995	46 Count	295 Count	36 Count
1791100194	31 Count	200 Count	22 Count
1791098393	147 Count	1189 Count	128 Count
1791096592	120 Count	937 Count	103 Count
1791094791	98 Count	710 Count	82 Count
1791092990	68 Count	510 Count	54 Count
1791091189	43 Count	274 Count	30 Count
1791089398	140 Count	1190 Count	134 Count
1791087597	119 Count	962 Count	115 Count
1791085797	94 Count	726 Count	91 Count
1791083996	71 Count	552 Count	70 Count
1791082195	35 Count	270 Count	35 Count
1791080395	136 Count	1002 Count	130 Count
1791078594	103 Count	785 Count	98 Count
1791076793	74 Count	578 Count	70 Count
1791074992	43 Count	327 Count	41 Count
1791073192	12 Count	79 Count	11 Count
1791071391	132 Count	1008 Count	129 Count
1791069590	104 Count	747 Count	102 Count
1791067799	69 Count	475 Count	68 Count
1791065997	37 Count	234 Count	37 Count
1791064197	177 Count	1085 Count	166 Count
1791062395	150 Count	874 Count	140 Count
1791060595	123 Count	656 Count	114 Count
1791058794	114 Count	631 Count	106 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)