APRS Track Direct

My position About ☰

reset

F1MCO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1MCO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1773352331	44 Count	952 Count
1773350528	43 Count	929 Count
1773348723	42 Count	900 Count
1773345116	40 Count	848 Count
1773343312	39 Count	798 Count
1773341508	38 Count	775 Count
1773339748	33 Count	750 Count
1773337944	32 Count	723 Count
1773336140	31 Count	692 Count
1773334336	30 Count	661 Count
1773332532	29 Count	593 Count
1773328924	27 Count	508 Count
1773327121	26 Count	481 Count
1773323513	24 Count	424 Count
1773321709	23 Count	394 Count
1773319905	22 Count	371 Count
1773318145	17 Count	349 Count
1773316341	16 Count	326 Count
1773314537	15 Count	297 Count
1773312733	14 Count	259 Count
1773310930	13 Count	239 Count
1773303714	9 Count	133 Count
1773301910	8 Count	110 Count
1773300106	7 Count	75 Count
1773298302	6 Count	57 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)