APRS Track Direct

My position About ☰

reset

WB6ETY-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WB6ETY-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1775824230	1372	780	386	774	37
1775823511	1372	781	386	774	38
1775823190	1374	781	386	774	37
1775822792	1372	782	386	779	36
1775822071	1378	782	386	779	35
1775821390	1372	785	386	779	37
1775821351	1374	785	386	779	36
1775820631	1372	786	392	779	35
1775819911	1375	787	386	784	36
1775819590	1372	788	386	784	35
1775819191	1372	788	386	784	36
1775818471	1374	789	392	788	35
1775817790	1375	790	386	788	36
1775817750	1372	790	392	788	38
1775817029	1372	792	386	788	36
1775816310	1372	794	392	788	36
1775815989	1372	794	392	788	35
1775815590	1372	795	397	788	35
1775814870	1375	796	397	792	35
1775814189	1372	797	397	792	35
1775814150	1372	797	397	792	35
1775813430	1372	798	397	792	35
1775812709	1381	798	392	797	35
1775812389	1372	798	392	797	35
1775811990	1384	799	397	797	35

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)