APRS Track Direct

My position About ☰

reset

F5ZZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773347750	301 Count	501 Count	239 Count
1773347144	287 Count	477 Count	229 Count
1773346538	276 Count	454 Count	220 Count
1773345932	261 Count	427 Count	209 Count
1773345326	248 Count	401 Count	200 Count
1773344719	234 Count	375 Count	189 Count
1773344113	215 Count	345 Count	177 Count
1773343511	198 Count	321 Count	164 Count
1773342905	183 Count	295 Count	153 Count
1773342299	170 Count	272 Count	143 Count
1773341692	155 Count	249 Count	133 Count
1773341086	144 Count	225 Count	125 Count
1773340481	130 Count	202 Count	114 Count
1773339874	117 Count	182 Count	103 Count
1773338661	90 Count	148 Count	82 Count
1773338055	80 Count	133 Count	74 Count
1773337449	71 Count	114 Count	66 Count
1773336843	47 Count	75 Count	43 Count
1773336237	31 Count	51 Count	28 Count
1773335630	16 Count	24 Count	16 Count
1773335024	555 Count	1010 Count	418 Count
1773334417	540 Count	986 Count	407 Count
1773333204	478 Count	913 Count	362 Count
1773332598	455 Count	885 Count	348 Count
1773331992	442 Count	858 Count	338 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)