APRS Track Direct

My position About ☰

reset

SP6TPX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6TPX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1775208697	28 Count	586 Count
1775206894	27 Count	573 Count
1775205091	26 Count	559 Count
1775203288	25 Count	533 Count
1775201485	24 Count	508 Count
1775199681	23 Count	486 Count
1775197878	22 Count	471 Count
1775196075	21 Count	443 Count
1775194272	20 Count	420 Count
1775192468	19 Count	401 Count
1775190665	18 Count	371 Count
1775188899	17 Count	347 Count
1775187096	16 Count	323 Count
1775185293	15 Count	304 Count
1775183490	14 Count	276 Count
1775181686	13 Count	248 Count
1775179883	12 Count	232 Count
1775178080	11 Count	212 Count
1775176277	10 Count	199 Count
1775174474	9 Count	179 Count
1775172671	8 Count	162 Count
1775170868	7 Count	149 Count
1775169065	6 Count	133 Count
1775167299	5 Count	126 Count
1775165496	4 Count	108 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)