APRS Track Direct

My position About ☰

reset

SR2JP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2JP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791101904	444 Count	691 Count
1791100223	435 Count	671 Count
1791098543	430 Count	650 Count
1791096862	425 Count	631 Count
1791095181	420 Count	610 Count
1791093500	414 Count	585 Count
1791091819	408 Count	564 Count
1791088707	394 Count	521 Count
1791087026	388 Count	499 Count
1791085345	382 Count	476 Count
1791083665	375 Count	452 Count
1791081984	368 Count	424 Count
1791080303	362 Count	394 Count
1791078622	356 Count	376 Count
1791076942	349 Count	355 Count
1791075261	343 Count	336 Count
1791073580	337 Count	316 Count
1791071899	328 Count	297 Count
1791070218	323 Count	274 Count
1791067106	310 Count	233 Count
1791065425	303 Count	211 Count
1791063745	296 Count	189 Count
1791062064	286 Count	162 Count
1791060383	273 Count	116 Count
1791058702	264 Count	98 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)