APRS Track Direct

My position About ☰

reset

SQ9IKM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IKM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780635378	31 Count	261 Count	27 Count
1780634477	26 Count	211 Count	23 Count
1780633577	20 Count	150 Count	18 Count
1780632677	12 Count	98 Count	11 Count
1780631774	6 Count	44 Count	6 Count
1780630873	221 Count	1054 Count	163 Count
1780629973	212 Count	981 Count	155 Count
1780629072	196 Count	922 Count	140 Count
1780628171	189 Count	867 Count	134 Count
1780627271	183 Count	826 Count	129 Count
1780626370	179 Count	777 Count	126 Count
1780625469	173 Count	729 Count	121 Count
1780624568	167 Count	685 Count	116 Count
1780623668	164 Count	644 Count	114 Count
1780622768	160 Count	616 Count	111 Count
1780621867	155 Count	575 Count	107 Count
1780620981	150 Count	532 Count	103 Count
1780620080	148 Count	505 Count	102 Count
1780619180	144 Count	486 Count	99 Count
1780618279	138 Count	469 Count	94 Count
1780617378	135 Count	452 Count	92 Count
1780616478	133 Count	431 Count	91 Count
1780615577	131 Count	419 Count	90 Count
1780614676	129 Count	412 Count	89 Count
1780613776	127 Count	401 Count	88 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)