APRS Track Direct

My position About ☰

reset

SP8SOB-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8SOB-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1791088692	452 Count	561 Count	305 Count
1791087791	448 Count	555 Count	302 Count
1791086891	445 Count	550 Count	300 Count
1791085990	442 Count	546 Count	298 Count
1791085090	439 Count	542 Count	296 Count
1791084189	435 Count	538 Count	293 Count
1791083289	432 Count	534 Count	291 Count
1791082388	429 Count	529 Count	289 Count
1791081487	425 Count	523 Count	286 Count
1791080587	421 Count	518 Count	283 Count
1791079686	417 Count	512 Count	280 Count
1791078785	413 Count	506 Count	277 Count
1791077885	405 Count	496 Count	270 Count
1791076984	401 Count	490 Count	267 Count
1791076084	397 Count	484 Count	264 Count
1791075183	393 Count	478 Count	261 Count
1791074282	389 Count	472 Count	258 Count
1791073382	386 Count	467 Count	256 Count
1791072481	382 Count	461 Count	253 Count
1791071580	378 Count	455 Count	250 Count
1791070680	374 Count	449 Count	247 Count
1791069779	370 Count	443 Count	244 Count
1791068879	366 Count	437 Count	241 Count
1791067978	362 Count	431 Count	238 Count
1791067078	358 Count	425 Count	235 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)