APRS Track Direct

My position About ☰

reset

F5ZMX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZMX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780619943	19 Count	140 Count	2 Count
1780619039	18 Count	132 Count	2 Count
1780618136	17 Count	123 Count	2 Count
1780617233	16 Count	115 Count	2 Count
1780616329	15 Count	109 Count	2 Count
1780615426	14 Count	103 Count	2 Count
1780613619	12 Count	90 Count	2 Count
1780612716	11 Count	82 Count	2 Count
1780611813	10 Count	76 Count	2 Count
1780610909	9 Count	65 Count	2 Count
1780610006	8 Count	59 Count	2 Count
1780609103	7 Count	51 Count	2 Count
1780608199	6 Count	44 Count	2 Count
1780607296	5 Count	37 Count	2 Count
1780606392	4 Count	29 Count	2 Count
1780605489	2 Count	17 Count	1 Count
1780604586	1 Count	9 Count	1 Count
1780603682	123 Count	1010 Count	9 Count
1780602779	121 Count	998 Count	8 Count
1780601875	119 Count	988 Count	7 Count
1780600972	118 Count	981 Count	7 Count
1780600069	117 Count	970 Count	7 Count
1780599165	116 Count	960 Count	7 Count
1780598340	115 Count	947 Count	7 Count
1780597437	114 Count	938 Count	7 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)