APRS Track Direct

My position About ☰

reset

SR8RZE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8RZE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785836666	39 Count	339 Count	25 Count
1785835766	37 Count	324 Count	24 Count
1785834865	35 Count	307 Count	23 Count
1785833964	33 Count	292 Count	22 Count
1785831262	28 Count	262 Count	20 Count
1785830361	25 Count	243 Count	18 Count
1785829461	13 Count	207 Count	7 Count
1785828560	11 Count	178 Count	6 Count
1785827659	9 Count	149 Count	5 Count
1785826759	7 Count	122 Count	4 Count
1785825858	5 Count	92 Count	3 Count
1785824957	3 Count	56 Count	2 Count
1785824057	1 Count	23 Count	1 Count
1785822255	53 Count	970 Count	26 Count
1785821355	51 Count	941 Count	25 Count
1785820454	49 Count	908 Count	24 Count
1785819553	47 Count	874 Count	23 Count
1785817767	39 Count	795 Count	21 Count
1785816867	37 Count	751 Count	20 Count
1785815966	34 Count	715 Count	18 Count
1785815065	32 Count	683 Count	17 Count
1785814165	30 Count	651 Count	16 Count
1785813264	28 Count	617 Count	15 Count
1785812363	26 Count	585 Count	14 Count
1785811463	24 Count	546 Count	13 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)