APRS Track Direct

My position About ☰

reset

SQ9OE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9OE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775206969	443 Count	813 Count	449 Count
1775205169	443 Count	798 Count	449 Count
1775203368	443 Count	775 Count	449 Count
1775201568	442 Count	749 Count	448 Count
1775199768	441 Count	731 Count	447 Count
1775197968	441 Count	722 Count	447 Count
1775196168	441 Count	722 Count	447 Count
1775194368	441 Count	722 Count	447 Count
1775192568	441 Count	722 Count	447 Count
1775190768	441 Count	722 Count	447 Count
1775188968	441 Count	720 Count	447 Count
1775187168	440 Count	717 Count	446 Count
1775185368	438 Count	706 Count	444 Count
1775183568	437 Count	682 Count	443 Count
1775181767	436 Count	662 Count	442 Count
1775179967	433 Count	649 Count	439 Count
1775178167	431 Count	637 Count	437 Count
1775176367	429 Count	623 Count	435 Count
1775174567	429 Count	617 Count	435 Count
1775172767	429 Count	616 Count	435 Count
1775170967	429 Count	616 Count	435 Count
1775169167	429 Count	613 Count	435 Count
1775167367	429 Count	606 Count	435 Count
1775165567	429 Count	606 Count	435 Count
1775163766	429 Count	606 Count	435 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)