APRS Track Direct

My position About ☰

reset

LW2DQC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DQC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780606474	654 Count	2 Count	2 Count
1780604670	653 Count	2 Count	2 Count
1780602867	652 Count	2 Count	2 Count
1780601063	651 Count	2 Count	2 Count
1780599259	650 Count	2 Count	2 Count
1780597455	649 Count	2 Count	2 Count
1780595652	648 Count	2 Count	2 Count
1780593848	647 Count	2 Count	2 Count
1780592087	646 Count	2 Count	2 Count
1780590283	645 Count	2 Count	2 Count
1780588480	644 Count	2 Count	2 Count
1780586676	643 Count	2 Count	2 Count
1780584873	642 Count	2 Count	2 Count
1780583069	641 Count	2 Count	2 Count
1780581265	640 Count	2 Count	2 Count
1780579462	639 Count	2 Count	2 Count
1780577658	638 Count	2 Count	2 Count
1780575855	637 Count	2 Count	2 Count
1780574051	636 Count	2 Count	2 Count
1780572248	635 Count	2 Count	2 Count
1780570487	634 Count	2 Count	2 Count
1780568683	633 Count	2 Count	2 Count
1780566880	632 Count	2 Count	2 Count
1780565076	631 Count	2 Count	2 Count
1780563273	630 Count	2 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)