APRS Track Direct

My position About ☰

reset

EA7HQG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA7HQG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785847732	191 Count	536 Count	176 Count
1785845929	183 Count	513 Count	169 Count
1785844126	175 Count	495 Count	162 Count
1785842323	168 Count	481 Count	156 Count
1785840519	160 Count	465 Count	149 Count
1785838716	106 Count	378 Count	96 Count
1785836913	98 Count	301 Count	89 Count
1785835110	71 Count	196 Count	63 Count
1785833344	34 Count	128 Count	30 Count
1785831541	28 Count	104 Count	25 Count
1785829738	23 Count	83 Count	21 Count
1785827934	17 Count	59 Count	16 Count
1785826131	8 Count	31 Count	8 Count
1785824328	338 Count	1025 Count	298 Count
1785822525	331 Count	988 Count	292 Count
1785820722	321 Count	950 Count	283 Count
1785818919	314 Count	917 Count	277 Count
1785817115	307 Count	888 Count	271 Count
1785815312	298 Count	861 Count	263 Count
1785813509	288 Count	827 Count	254 Count
1785811755	280 Count	799 Count	247 Count
1785809949	271 Count	767 Count	239 Count
1785808143	258 Count	736 Count	227 Count
1785806337	247 Count	669 Count	217 Count
1785804531	239 Count	632 Count	210 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)