APRS Track Direct

My position About ☰

reset

DL1KDA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL1KDA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1780765075	367 Count	568 Count	290 Count
1780763271	359 Count	549 Count	283 Count
1780761466	350 Count	532 Count	275 Count
1780759711	349 Count	532 Count	275 Count
1780757907	340 Count	515 Count	267 Count
1780756103	333 Count	502 Count	261 Count
1780754299	325 Count	488 Count	254 Count
1780752495	319 Count	473 Count	249 Count
1780750691	314 Count	469 Count	245 Count
1780748886	313 Count	469 Count	245 Count
1780747082	306 Count	463 Count	239 Count
1780745278	301 Count	459 Count	235 Count
1780743474	294 Count	453 Count	229 Count
1780741669	287 Count	447 Count	223 Count
1780739865	273 Count	438 Count	215 Count
1780738111	262 Count	428 Count	205 Count
1780736307	257 Count	424 Count	201 Count
1780734503	251 Count	414 Count	196 Count
1780732698	249 Count	408 Count	195 Count
1780730894	243 Count	394 Count	190 Count
1780729089	238 Count	385 Count	186 Count
1780727285	236 Count	381 Count	185 Count
1780725481	232 Count	374 Count	182 Count
1780723677	229 Count	367 Count	180 Count
1780721873	228 Count	365 Count	180 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)