APRS Track Direct

My position About ☰

reset

M9NSZ-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M9NSZ-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791118312	146 Count	951 Count
1791116507	145 Count	949 Count
1791114704	144 Count	940 Count
1791112901	143 Count	931 Count
1791111098	142 Count	920 Count
1791109295	141 Count	909 Count
1791105689	139 Count	893 Count
1791103886	138 Count	886 Count
1791102083	137 Count	882 Count
1791100279	136 Count	876 Count
1791098476	135 Count	864 Count
1791078682	124 Count	826 Count
1791075109	122 Count	823 Count
1791073306	121 Count	818 Count
1791071503	120 Count	810 Count
1791069700	119 Count	807 Count
1791067897	118 Count	807 Count
1791066094	117 Count	804 Count
1791064291	116 Count	801 Count
1791062488	115 Count	801 Count
1791060685	114 Count	798 Count
1791058882	113 Count	794 Count
1791057078	112 Count	794 Count
1791055275	111 Count	794 Count
1791053508	110 Count	793 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)