APRS Track Direct

My position About ☰

reset

G0DUB-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object G0DUB-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782135565	222 Count	452 Count	200 Count
1782133762	212 Count	437 Count	191 Count
1782131959	204 Count	423 Count	184 Count
1782130192	195 Count	409 Count	176 Count
1782128389	186 Count	392 Count	168 Count
1782126586	178 Count	377 Count	161 Count
1782124783	170 Count	359 Count	154 Count
1782122980	161 Count	342 Count	146 Count
1782121177	153 Count	324 Count	139 Count
1782119374	137 Count	275 Count	124 Count
1782117570	127 Count	238 Count	115 Count
1782115768	117 Count	220 Count	106 Count
1782113964	109 Count	206 Count	99 Count
1782112161	99 Count	187 Count	90 Count
1782110358	91 Count	170 Count	83 Count
1782108592	82 Count	154 Count	75 Count
1782106789	67 Count	126 Count	61 Count
1782104986	54 Count	101 Count	49 Count
1782103183	45 Count	87 Count	41 Count
1782101380	35 Count	70 Count	32 Count
1782099577	26 Count	53 Count	24 Count
1782097773	16 Count	36 Count	15 Count
1782095970	7 Count	17 Count	7 Count
1782094167	638 Count	1016 Count	575 Count
1782092364	631 Count	999 Count	569 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)