APRS Track Direct

My position About ☰

reset

PE1PMD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PMD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791122812	190 Count	304 Count	93 Count
1791121909	185 Count	297 Count	91 Count
1791121005	183 Count	293 Count	90 Count
1791120186	181 Count	289 Count	89 Count
1791119286	179 Count	284 Count	88 Count
1791118378	177 Count	282 Count	87 Count
1791117475	175 Count	278 Count	86 Count
1791116571	173 Count	274 Count	85 Count
1791115667	171 Count	269 Count	84 Count
1791114764	169 Count	264 Count	83 Count
1791113860	167 Count	258 Count	82 Count
1791112957	165 Count	254 Count	81 Count
1791112055	163 Count	249 Count	80 Count
1791111150	162 Count	246 Count	80 Count
1791110246	160 Count	242 Count	79 Count
1791109343	159 Count	239 Count	79 Count
1791108439	157 Count	235 Count	78 Count
1791106632	153 Count	229 Count	76 Count
1791105728	151 Count	226 Count	75 Count
1791104824	149 Count	222 Count	74 Count
1791103921	147 Count	219 Count	73 Count
1791103017	145 Count	215 Count	72 Count
1791102115	143 Count	211 Count	71 Count
1791101210	141 Count	207 Count	70 Count
1791100307	139 Count	200 Count	69 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)